PCI-104 Specification
A POSSIBLE MODULE STACK CONFIGURATION . . and INT signals for the expansion module, the rotary switch must be adjusted for the position on the stack . AD10. M66EN. 7. AD14. AD13. GND. AD12. 8. +3.3V. C/BE1#. AD15. + 3.3V. 9 .
http://www.controlled.com/pc104faq/PCI-104v1_0.pdf

PC/104-Plus Specification
Added PC/104 8-Bit and 16-Bit Connector Specification. c. . to allow for a 4th bus mastering expansion module on a PC/104-Plus stack. . and INT signals for the expansion module, the rotary switch must be adjusted for the position on . AD10. M66EN. 7. AD14. AD13. GND. AD12. 8. +3.3V. C/BE1#. AD15. +3.3V. 9 .
http://www.controlled.com/pc104faq/PC104-Plusv2.0.pdf



Stack Light
Rotary Switches. The DeviceNet Stack Light has three 10-position rotary switches for setting: . Parameters 8, 10, 12, 14, 16 Module Mode. Parameter 17 .
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/855t-um001_-en-p.pdf

800T-TD001A-US-P: Bulletin 800T Watertight/Oiltight Selector ...
Special three-position and four-position selector switch arrangements listed in the Industrial Control catalog . (7/8 vs. 11/8 deep). Refer to Shallow Contact Block Ratings table above. PenTUFF Blocks . One Stack. Two Stacks . Page 14. The OXO circuit can be obtained from by mounting a Catalog. Number 800T- XD2 .
http://literature.rockwellautomation.com/idc/groups/literature/documents/td/800t-td001_-en-p.pdf

Industrial Control - 30 mm
3-Position Selector Switch, Click to enlarge - 800T_800H-1_3-8, 1 N.O. - 1 N.C. . A2 and A2R contact blocks cannot be stacked upon, but can stack on other contact blocks. ? Jumbo . Switch?. 14, D118, , , D2M, 1 N.C., D1P, 1 N.O. .
http://www.ab.com/en/epub/catalogs/12768/229240/229244/2531083/tab4.html